i want to send a command from my Android phone -> to Bluemix -> to Raspberry pi.
The commands will be ON / Off led and I followed the sample code as well as the instructions in this wiki.
It is a great wiki and has good lot of information.
I have an account with IBM Bluemix and created a service, but when I connect to the Bluemix -I was hoping to see a connection on Bluemix Launch Dashboard console - I don't see it.
However the Evothings workbench reports it is connected to the IoTF. The Publish ( I m sending a sample JSON value ) goes thru( as seen on the tools debug console), the subscribe() in the painter Evothings code receives it -BUT the IBM Blue mix portal does NOT indicate that the connection happened.
So, my question was - at the time of your development - did you validate or see some visual data on Bluemix IoTF - somewhere that the Evothings Android APP did in fact connect and send data to IoTF and if so - how did you validate it.
BTW: i like the Workbench and it is easy to use and pretty fast - I like the tools that go with it as well and the most valuable automation is that the Workbench immediately notices that I changed the code and loads it- instantly - Good work. ..
Ask, and ye shall receive.
2 posts • Page 1 of 1
I forgot to add 'I have a IoTF service ( that I picked up from under the CATALOG) of the Bluemix. I have a raspberry Pi - device that I created and I can send data from RPi to Bluemix IoTF and it works - I was wondering if this Android phone also has something similar that I have to do in Bluemix IoTF.
Who is online
Users browsing this forum: No registered users and 13 guests